Check out the latest coupon codes -->

 

My store will be open intermittently as I continue to handle the necessary work on the death of a family member. 

Tutorial Bundle Earthstar and Revolving Planet Wire Wrap Pendants

Tutorial Bundle Earthstar and Revolving Planet Wire Wrap Pendants
Earthstar Tutorial Step 1
Tutorial Bundle Earthstar and Revolving Planet Wire Wrap Pendants Earthstar Tutorial Step 1
Tutorial Bundle Earthstar and Revolving Planet Wire Wrap Pendants
$9.75
Only 25 available

Tutorial Bundle Earthstar and Revolving Planet Wire Wrap Pendants

Bundle contains two tutorials. The Earthstar Tutorial and the Revolving Planet Tutorial. These are full tutorials that will teach you how wire wrap a crystal point and a heart shaped stone.

** PLEASE NOTE - this listing is for the TUTORIALS only, you will not be receiving a kit, finished piece or tools.**

You will receive your tutorials in an email as a PDF instantly upon purchase. The earthstar tutorial is 22 pages long, with 57 fully illustrated easy to follow steps. The Revolving Planet tutorial is 41 pages long, with 44 fully illustrated easy to follow steps.

Knowledge requirements: basic wire wrapping, weaving techniques, and hand forming basic shapes such as curls and forming loops.

Intended audience:  Advanced beginner to intermediate wire wrapping skills.

Earthstar Materials and supplies:                                                            

5 pieces of 20ga (0.81cm) dead soft wire 13” (33cm) each
260” (660cm) 28ga (0.32cm) wire.  Depending on how tightly you wrap, the length may require more or less.)
30mm oval bead (center drilled)
Chain, ribbon, or cord. Length of your choosing.

Tools:
Flush cutters
Chain nose or long nose pliers
Bail maker pliers (or dowel rod, knitting needle, or pencil)

Optional tools:
Tweezers pliers
Bent nose pliers
Round nose pliers
Nylon jaw pliers
Ruler or measuring tape
Bobbin (used to manage weaving wire)

Revolving Planet Materials and supplies:

Check to verify that the 20ga wire will fit through the hole of the bead. If not, replace all occurrences of 20ga (.081cm) dead soft wire with 22ga (0.64cm) dead soft wire.

Supplies:
6 pieces of 20ga (0.81cm) dead soft wire 13” (33cm) each
or, 6 pieces 22ga (0.64cm) dead soft wire 13” (33cm) each
200” (508cm) 28ga (0.32cm) wire
28mm round bead (center drilled)
3mm bead
8mm ID (inside diameter) open jump ring
Chain, ribbon, or cord (I used 3.2mm copper ball chain with 11.2 x 4.2mm connector). Length of your choosing.

Tools:
Flush cutters
Chain nose or long nose pliers

Optional tools:
Tweezers pliers
Bent nose pliers
Nylon jaw pliers
Ruler or measuring tape
Bobbin (used to manage weaving wire)

Please do not distribute, lend or copy.
Do not mass produce.
Please give credit to the Instructor.

You may sell products produced from Sharon Burnett, Artisan tutorials when constructed by the purchaser only.